Many settings are printed on the BOCA self-test ticket. These can be useful when settings may need to be changed.
The self-test ticket can easily be printed by pressing the TEST button on the control panel
Below is a typical self-test ticket on 3.25" wide and 5.5"or longer tickets. On Smaller ticket only a part of the full self-test ticket may be printed.
1 | Serial number |
2 | Ticket counters (PTC = permanent counter; RTC = resettable counter) |
3 | Firmware version |
4 | Resident font version |
5 | Time printer is switch on (DAYS : HOURS : MINUTES : SECONDS) |
6 | Ethernet settings (IP address; MAC address; SubNet Mask; Default Gateway) |
7 | Expansion FLASH enabled |
8 | Bluetooth enabled (if installed) |
9 | USB enabled (Yes or No) Note: On newer firmware the device type setting is shown (PRINTER, HID or SERIAL) |
10 | Resolution (DPI) |
11 | Transparent mode enabled |
12 | Cutter enabled (MINI) / disabled (MICRO) |
13 | Status replies send to (status is always send via the ethernet port) |
14 | Special head setting |
15 | Cut count (for path1 and path 2) |
16 | Measured size of the installed print head |
17 | Measured ticket length in dots |
18 | Baud rate setting for serial port |
19 | Current print speed |
20 | Measured print width in dots |
21 | Shuffle mode enabled |