The adjustable infeed guide (p/n: A424069-Z-7) enables the Lemur-Z to be used with 2” to 3.22” wide media when the external adjustable infeed guide is not practical. For 3.25” wide media the guide is not needed.



The below reviews how to install the optional infeed guide. 

  1. The guide is mounted onto the back of the Lemur-Z using the hole shown in the photo below.

  2. Use the #4 -40 self-tapping screw that came with guide to mount it onto the printer. Firmly hold the guide down while tightening the screw.

  3. The guide may be adjusted for media widths in between the two above mentioned positions. The guide comes with four index slots that match up with the slot on the printer for the desired index width.