Printer (menu) settings

Change special head setting (print head setup for RADJW & RADJ4 only)
This manual is only applicable to full size Lemur RADJW & RADJ4 paper guide printers. The special head settings are not supported on Lemur-X and Lemur-C...
Thu, 12 Oct, 2023 at 12:09 PM
Change print speed
Print speed controls the speed the ticket travels at. The slower the speed the darker the printing. The values can range from 0-7. Value Speed 0 Fast...
Thu, 26 Mar, 2020 at 12:25 PM
Change print intensity
Print intensity controls the darkness of ticket print out.  In the printer’s menu you have the following choices. Intensity LIGHT MED LIGHT NORMA...
Thu, 26 Mar, 2020 at 12:26 PM
Change baud rate setting for serial port
The baud rate controls the serial interface baud rate, parity bit, data bits and stop bits which can be set to different speeds where 9600,N,8,1 is default ...
Thu, 18 Jan, 2024 at 10:31 AM
Change Ethernet to dynamic IP address setup
When using a (DHCP) dynamic IP address make sure the ‘ETHERNET’ setting is set to ‘DHCP/SUB/GATE’. Please follow these steps to set a dynamic IP address on ...
Mon, 26 Feb, 2024 at 10:41 AM
Change Ethernet to static IP address setup
When using a (fixed) static IP address make sure the ‘ETHERNET’ setting is set to ‘YES’. Please follow these steps to set a static IP address on your Ethern...
Mon, 26 Feb, 2024 at 10:41 AM
Reset to factory default settings
The printer can be reset to the factory defaults using a few different methods. Be aware that all custom settings made to the printer will be lost. Using ...
Thu, 26 Mar, 2020 at 12:32 PM
Clear download space
This procedure will clear all stored logos and fonts stored in the user accessible memory. They will be permanently deleted. Depress both the MENU and ...
Fri, 1 May, 2020 at 2:20 PM
Change Mini/Micro setting (cutter control)
The Mini/Micro? setting defines if the printer has a cutter unit installed.  Value Description FGL command MINI Is for a printer with a Cutter Assembly...
Tue, 16 Jun, 2020 at 5:55 PM
Change ticket mode
During normal (multiple ticket mode) operation, the printer will stop for several hundred milliseconds within each ticket to allow the cutter to cycle.  Thi...
Thu, 29 Feb, 2024 at 10:07 AM